Replacement

Installation and Maintenance

Notes:

1. Turn over the robot and press the two latches inwards to remove

the main brush cover.

2. Remove the old main brush and install the new one.

3. Press on the main brush cover to lock it in place.

1. Pull out the main brush and remove the main brush bearing on

the left as shown in the picture. Remove any entangled hair or

dirt at both ends of the main brush. Then, reinstall the main brush

bearing.

2. To reinstall the main brush, snap the ends of the main brush into

place. Only after the main brush is securely installed, fit the main

brush cover. Make sure the teeth of the main brush cover are fully

seated in the slots, and press the main brush cover until you hear

a click.

• Clean every 2 weeks and replace every 6-12 months. The frequency of

replacement may vary with the actual situation. If abnormal wear occurs,

replace the main brush immediately.

• The product must be switched off and the plug must be removed from the

socket outlet before cleaning or maintaining the product.

• It is recommended to wipe the main brush with a wet cloth. If the main brush

is soaked, air-dry it away from direct sunlight.

• Do not use corrosive cleaning fluid or disinfectant to clean the main brush.

* Images are for illustration purposes only and may not exactly represent the product.